ENCANTO Brazilian Blow Dry Keratin Treatment Kit?
Keratin straightening can be carried out on any type of dyed hair, highlights, wavy, straight, curly, natural, and damaged after previous treatments. It is not recommended to apply the treatment on thin, brittle hair from bleaching and decolorizing hair.
The treatment can be repeated every 4-5 months, or where required
For best Results treatment should be applied 2 weeks prior or after colouring
How to use:
SETP 1: Preparation
Wash hair with CLARIFYING SHAMPOO set (No. 1). Depending on the needs, clean the hair 2-3 times. This is a very important process that aims to remove all impurities and residues after chemical treatments, coloring and stylizations. After a lot of rinsing, dry your hair with a towel to get rid of excess water.
STEP2: Mix & Apply (Patch test Required ** See Below)
STRAIGHTENING TREATMENT (No. 2) Sake well Before Use. Squeeze the desired amount into the bowl.? divide hair into small parts. It’s best to start with the lower parts and move upwards. Using a brush, apply on thin strands of hair about 1-2cm from the scalp, to the ends, while avoiding the skin an scalp. Make sure you do not miss any bandwidth. After covering the entire hair, wait 15 minutes.
When using a dryer, dry the hair with medium-warm airflow until Completely dry.? Use? a Heated hair straightener to 215-230 degrees C. Thin hair strands straighten with a straightener. Each band should be straightened 6-7 times, with a few seconds interval between straightening. For the hair’s push-up effect, straighten it keeping the strands up. After straightening out all the bands, wait 30min.
Wash hair again with CLARIFYING SHAMPOO (No. 1) and dry with towel. Apply POST-TREATMENT CONDITIONER (No.3) on the moist hair, divide the hair into small bands and apply conditioner 1-2 cm from the scalp, right to the ends. After applying to all the hair, wait for 15 minutes and rinse your hair so that 50% of the previously applied conditioner is left on them.
Again, dry the hair with medium-warm airflow, until dry. Warm up the hair straightener to a temperature of 215-230 degrees C and straighten the small hair strands in turn, repeating the straightening of each band 6-7 times.
** Patch test required Prior to application of stage 2. Apply small amount to back of hand or neck and wait for 1-2 hours. If no irritation or redness proceed to treatment.***